Welding & repair

Mobile Welding

Mobile welding means we bring the welder to you when the steel cannot travel: gate posts, fence runs, railings and equipment too big to haul.

A red welder set up on stone steps beside a new steel handrail on a job site

Some steel can travel to a shop and some cannot. A gate post in the ground, a long fence run, a stair rail and a broken part on heavy equipment all stay where they are. For those jobs the welder comes to you.

Most mobile work is repair. A cracked weld, a torn hinge tab, a bent rail, a broken bracket or a rusted picket can be ground out and welded where it stands. We weld steel only, with MIG, stick and flux-core.

Other jobs belong on the bench. A gate leaf that has racked out of square has to be clamped flat and braced before anything is welded, so it comes to the shop. The same goes for a part that must be cut, fitted and checked against a drawing. A photo of the problem usually settles which way it goes. Gate repair and steel fence repair cover more on gates and fences.

Welding throws sparks, so a mobile job starts with a look at what can burn. OSHA's welding rule says to move combustibles at least 35 feet from the work where that is practical. Where they cannot move, they are covered or shielded, and where a fire watch is required it runs at least a half hour after the welding stops. Dry brush, wood fences and wood decks beside the work are the first things we look for.

Galvanized steel needs extra care. Welding burns the zinc coating off around the weld and gives off zinc fumes. OSHA's rule spells out ventilation for zinc coated metal indoors and in confined spaces. Open air helps outdoors, but the bare spot still rusts first, so a repair on galvanized steel needs its coating renewed. ASTM A780 covers the repair methods, and zinc rich paint is one of them.

To price a job we need the address, a photo of the break and what the steel is. For a gate, add the opening width and a photo of the hinge side. Estimates are free.

Mobile work runs from both shops. Lancaster covers the Antelope Valley and Sun Valley covers the San Fernando Valley. Both shops are open weekdays, 8 to 5, with someone on call on weekends.

We do not wire gate operators, and wood, vinyl and chain link go to another trade.

Our work

Work from our shops

A red Lincoln Power MIG welder on a shop floor
A Lincoln Power MIG welder.
A steel handrail beside stone steps
A steel handrail beside stone steps.
Close-up of weld beads on a steel plate
Weld beads on steel plate.
FAQ

Questions about mobile welding

What can you weld at my property?

Cracked welds, torn hinges, bent rails, broken brackets and rusted pickets on steel gates, fences and railings, plus broken steel parts on equipment. If the steel can be reached and is sound enough to weld, it can usually be fixed where it stands.

Can every repair be done on site?

No. Some damage needs a flat bench and clamps. A gate leaf that has twisted out of square is the common one. It has to be pulled flat and braced before it is welded, or the sag gets locked in. Those leaves come to the shop.

Do you weld aluminum?

No. We weld steel only, with MIG, stick and flux-core.

Can you weld galvanized gates and fences?

Yes, with care. Welding burns off the zinc and gives off zinc fumes, so the work is best done in open air. The repaired spot then needs its coating renewed.

How do I get a price?

Send the address, a photo of the break and what the steel is, or call the shop nearest you. For a gate, add the opening width and a photo of the hinge side. Estimates are free.

Do you come out on weekends?

The shops run weekdays, 8 to 5, and are closed on weekends. Someone is on call, so call if something cannot wait.

Need mobile welding?

Free estimates. Tell us the job and we will send back a spec and a price.