Steel Privacy Fence in Leona Valley, CA

DM Welding builds solid steel panel fencing. On a Leona Valley perimeter the district rule takes it off the table. Under 22.330.060.B, perimeter fencing has to be an open, permeable design that does not block the view, and that holds where the fence goes up to protect horses and livestock too. The code gives examples of what qualifies, such as wood rail, steel pipe, vinyl rail, PVC pipe, recycled plastic rail and coated wire.

Retaining walls are the exception the section names. A steel privacy panel is not a retaining wall, so that exception does nothing for a privacy run. The rule applies no matter who builds the fence or what the quote calls it.

What fits a Leona Valley property line is open steel. Steel pipe is on the district's list, so a welded pipe rail fence uses a named material rather than one argued into compliance. Air passes between the rails, so the posts and footings carry far less wind than a solid run of the same height would put on them. Height still comes from LA County Code 22.110.070: 3 feet 6 inches in a required front yard and 6 feet in an interior side or rear yard.

Privacy closer to a Leona Valley house is a separate matter, and it belongs to county planning. The district text is written about perimeter fencing. Whether a solid screen set back inside the lot, around a patio or a yard, counts as perimeter fencing, and what height and position it would need, are not things we can promise. Take planning a sketch of where you want it. If they approve a solid screen inside the property, we can talk about building it then.

A solid face also asks more of the ground. With no gaps, the whole panel catches the wind and pushes that load into each post and footing. A solid run needs a heavier post section, closer spacing and deeper concrete than an open fence of the same height. On an exposed valley lot that cost comes before the district rule even enters the picture.

If you already hold a quote for a solid perimeter run in Leona Valley, check it against the district section before any deposit changes hands. Ask the person who quoted it how it fits 22.330.060.B, and confirm with county planning before anyone builds.

Open pipe rail in Leona Valley sun still needs its finish done right. Pipe is a closed section, so anything going to a galvanizer needs vent and drain holes, and caps keep water out of the tops. ASTM A123 sets zinc thickness by the steel. Powder over that zinc, prepped under ASTM D7803, makes a duplex finish the American Galvanizers Association puts at roughly 1.5 to 2.3 times the combined life of the two coatings used alone.

This work runs out of our shop on Division Street in Lancaster. Read the full steel privacy fence details, or call (818) 220-8704 and we will come out.